APPLICATION:
An ideal primer for levelling the absorption of mineral surfaces
that over time has irregular parameters (for deep penetration
use Active Primer). Can be used on and under paints, plasters,
wallpaper, self-levelling floors, acrylic and mineral plaster,
joint less floors, tiles, etc. It makes a good insulation layer
for surfaces stained by cigarette smoke and grease.
Note:
Do not use active primer when a bonding primer is required
Priming surfaces that are too "fresh", unseasoned
plaster or other surfaces (with unbalanced air/surface humidity)
are liable to "burn-outs".
PREPARING SURFACES & USAGE:
Surfaces should be clean and free of dirt and grease.
It can be applied with various tools such as brush, roller or
spray, depending on the absorption of the surface and porosity.
A test should be performed on a few square metres to estimate
the number of layers and consistency required.
More water is required when the temperature exceeds 30°C
or when working on a warm surface.
Please bare in mind the following:
An over-primed surface will cause paint smearing on the primed
layer (looking up towards the light the surface reflects light
like glass). To cure this problem, dilute the paint until it
is of sufficient consistency to "catch" on the over-primed
surface.
The absorptive quality of the surface should be directly compared
using sprayed water droplets with a sample of low absorptive
material (e.g. plasterboard) until such time as they are similar.
Highly absorptive surfaces greatly reduce the efficiency of
paint, and thus increase costs.
RENO GRUNT can be used as an insulation layer for surfaces stained
by cigarette smoke and grease. In such circumstance it should
not be diluted. In the case of very greasy surfaces, 3 coats
may be required (use "wet on dry" method).
For less greasy surfaces prime and then test. If required prime
with further coats. It should be noted that after multiple primer
layers to counteract grease, the surface will be typically "over-primed",
and thus the first layer of paint should be diluted in a ratio
1:1.
EFFICIENCY:
Average total usage depends totally on the reason the primer
is being used. For strengthening and regulating the absorption
for surfaces with medium absorption the usage will be 0.08-0.14
l/m2. For new surfaces where we are balancing the absorption
between different materials (e.g. plasterboard and joining
materials), usage will be close to 0.05 l/m2.
STORAGE, USE AND
TRANSPORT:
R.P. should be stored, used and transported in its originally
closed packaging at a temperature of +5° - +35°C (also
includes surface temperature) and in clean dry conditions.
Protect from frost.
BEST BEFORE: 2 years from
date of production.
SAFETY:
S2 Keep away from children
S26 In the event of eye contact wash with large quantities
of water and consult your doctor.
Polish Atest PZH: HK/B/0566/02/99
|
